liquid-liquid separation

英 [ˈlɪkwɪd ˈlɪkwɪd ˌsepəˈreɪʃn] 美 [ˈlɪkwɪd ˈlɪkwɪd ˌsepəˈreɪʃn]

网络  液-液分离

化学



双语例句

  1. Application of Dispersive Liquid-Liquid Microextraction in the Separation and Preconcentration of Trace Elements
    分散液液微萃取新技术在痕量元素分析中的应用研究
  2. Studies on Microfluidic Chip-Based Liquid-Liquid Extraction and Multiphase Laminar Flow Separation Techniques
    微流控芯片液-液萃取和多相层流技术的研究
  3. A New HPV Genotyping Method Using Multiple Suspension Array and Its Applications in Clinical Diagonosis; Studies on Microfluidic Chip-Based Liquid-Liquid Extraction and Multiphase Laminar Flow Separation Techniques
    人乳头瘤病毒液态悬浮芯片基因分型方法的建立及临床应用的初步研究微流控芯片液-液萃取和多相层流技术的研究
  4. A Two-phase Turbulent Flow Model for Suspended Sediment Transport under Waves; Studies on Microfluidic Chip-Based Liquid-Liquid Extraction and Multiphase Laminar Flow Separation Techniques
    基于固液两相紊流理论的近岸悬移质泥沙运动数值研究微流控芯片液-液萃取和多相层流技术的研究
  5. Methods: Liquid-liquid partition, solid-phase separation extraction. silica-gel chromatography, Al2O3 chromatography and thin-layer chromatography were performed and compared for separation of paclitaxel.
    采用液-液萃取、固相萃取、硅胶柱层析、氧化铝柱层析、薄层层析五种分离方法对紫杉醇进行了初分离。
  6. Methods HPLC determination involved liquid-liquid extraction, separation on a CN column and ultraviolet detection at 310 nm with granisetron as an internal standard.
    方法采用液&液萃取,氰基柱分离,检测波长为310nm,格拉司琼为内标。
  7. Modelling and parameter evaluation of liquid-liquid separation processes with axial mixing
    具有轴向混合的液液传质分离过程的数学模型及计算方法
  8. Methods The PLLA scaffolds were fabricated by solution casting/ porogen leaching method, solid-liquid phase separation method and liquid-liquid phase separation method. The porosity and average pore diameter of the PLLA scaffold were measured and microstructure of the scaffolds was observed.
    方法分别用溶剂浇铸/致孔剂溶出法、固-液相分离法、液-液相分离法,制得了PLLA的多孔支架,测定其孔隙率及平均孔径,并观察其微观结构。
  9. After reaction, the system is converted into two phases, the unreacted substrate and products are in the same phase, and can be obtained through liquid-liquid separation.
    反应后变成两相体系,未反应的底物和生成物在一相,可直接液液分离。
  10. The inlet structure and the level of machining accuracy is one of the key factors which decide the separation and using performance of the liquid-liquid separation hydrocyclone.
    入口结构形式及加工精度的优劣是决定液&液分离水力旋流器分离性能及使用性能的关键因素之一。
  11. PS micro-ball embedded with activated carbon ( AC-PS) was prepared by liquid-liquid phase separation method and its adsorption function on bisphenol A ( BPS) was investigated.
    采用液-液相分离的方法制备了包埋活性炭的聚砜(活性炭-聚砜)微球,并考察了其对双酚A(BPA)的吸附功能。
  12. Study on Laser Testing of Flow Field in Liquid-liquid Separation Hydrocyclone Model
    液液分离水力旋流器流场激光测试研究
  13. Demonstration Station of Liquid-Liquid Rotating Flow Separation and Its Complete Process Technology
    液-液旋流示范站及配套工艺
  14. In addition, the present paper analyzed and discussed various factors affecting the glazes that and pointed out that the forming mechanism of high silver glaze is a liquid-liquid phase separation melt.
    本文还对影响这两种釉的各种因素进行了较详细的分析讨论,并指出了高银釉的形成机理是熔体液&液分相。
  15. Liquid-liquid Phase Separation Process and Numerical Simulation of Microstructure of Al-In Immiscible Alloys
    Al-In难混溶合金的液相分离过程及显微组织数值模拟
  16. Status and Application Perspectives of Hydrocyclones for Liquid-Liquid Separation
    液-液旋流分离管结构选型实验研究旋流分离技术的现状与应用前景
  17. Study of the Split ratio Characteristic coefficient of Hydrocyclone for Liquid-liquid Separation
    液-液旋流器分流比特性系数研究
  18. The relationship between pressure-drop ratio and flow rate, split ratio, overflow outlet diameter, bigger cone, and smaller cone in the liquid-liquid hydrocyclone separation are discussed in the paper.
    分析了入口总流量、分流比、溢流口直径与液-液水力旋流器压降比的关系,讨论了大、小锥角及入口尺寸比变化对压降比的影响。
  19. The product of saponification was isolated by a liquid-liquid phase separation with the upper phase of di-ether and the lower phase of 2% ( W/ V) NaCl solution.
    用乙醚和2%(W/V)的氯化钠水溶液液&液萃取皂化反应产物。
  20. There are part liquid-liquid phase separation for the blends of m-PE-LLD with PE-LD, and have a most co-crystallization at 20% PE-LD.
    PELD的加入使共混物结晶峰变宽,说明PELD与mPELLD共结晶行为较差,存在部分相分离,但在PELD含为20%时有最大结晶度,结晶速率有所提高;
  21. It is indicated by the morphology of the disperse phase under electron microscope that the opacity of glass is due to liquid-liquid phase separation.
    通过电子显微镜观察了乳浊分散相的形貌,说明玻璃乳油是由液相分离引起。
  22. Liquid-liquid heat exchanger with separation type vacuum phase transition
    分离型真空相变液-液换热的研究及其工业应用
  23. Numerical simulation of liquid-liquid turbulent separation flows in a double-cone hydrocyclone
    双锥型旋流器内液&液分离过程的流动数值模拟
  24. The phase separation rate during the membrane formation process was measured by the light transmission method. The liquid-liquid phase separation happens at about 1 minute after the gel demixing.
    光透射曲线法测定了成膜时的相分离速度,结果表明成膜过程中,在凝胶分相后约1min出现了液液分相。
  25. The formation of larger pores at inner surface is due to the replacement of the rich diluent phase formed near the inner surface via liquid-liquid phase separation.
    由于采用稀释剂作为芯液,内表面液-液相分离产生的稀释剂富相大液滴被稀释剂替换,从而形成大孔。
  26. The residue was extracted with acetone/ dichlomethane mixture. After liquid-Liquid separation with petroleum ether, silica gel column was used for cleanup. Gas chromatography was employed for detection.
    检测样本用丙酮+二氯甲烷提取后,再萃取到石油醚中,经硅胶柱净化后采用气相色谱法测定。
  27. Flotation method is a high effective way in solid-liquid or liquid-liquid separation field.
    气浮法是一种高效的固液或液液分离方法。
  28. The main use of hydrocyclone is from solid-liquid separation to liquid-liquid separation and liquid-liquid-solid separation and gas-liquid-solid separation.
    近二十年来,水力旋流器的用途也由主要进行固-液分离发展到液-液分离、液-液-固分离和气-液-固三相分离。
  29. Centrifugal separator is used in solid-liquid separation, liquid-liquid separation and gas-liquid separation widely as its simple structure, easy to manufacture and high separate efficiency.
    离心式分离器以其结构简单,加工制造容易,分离效率高,广泛的应用于固液分离、液液分离及气液分离中。